Rime-lite i flash Manuel d'utilisateur télécharger pdf

Introduction

Thank you for purchasing a RiMELITE product. The i-series battery built in strobe incorporates some

of the advance features in its lightweight and compact design. We are ascertain that you are excited

to start using the strobe right away. However, it is important to spare a 10 minutes to read through

this Manual first to handle the strobe correctly.

This strobe is primarily designed for on location photographer and photographer that travels to various

country with different AC voltage output. The built in high capacity Lithium ion battery hold sufficient

power to fire up to 600 Flashes at Full Power of 400w of i4 on a fresh full charge battery. This

should be sufficient for a normal shooting for a day before looking for an electricity outlet to charge

the strobe again.

Safety Instructions

1) The strobe (aka, flash unit) is designed exclusively for photographic use only

2) Never fire a flash in the vicinity of flammable gases or liquids! Danger on Explosion!

3) Never fire the flash to people or animal in the immediate vicinity of the eyes. It might damage the retina

and lead to severe visual disorder (including blindness) at close range.

4) Never fire flashes towards moving vehicle or people. They could be blinded by the flash and cause an

accident

5) Do not expose the strobe under excessive heat source such as hot sun or fire. Danger of explosion on the

battery.

6) Protect the strobe from excessive heat and humidity.

7) Do not touch the flash tube with bear hand especially after flash shots, as you may damage the tube and

burn yourself!

8) Allow at least 2 minutes interval after taking a series of 10 full light output shot in rapid order.

9) Never use charger with different specification to charge the strobe.

10) Do not over charge your strobe as it may damage the battery cells and cause explosion hazard.

11) Never try to open, repair and/or modify the strobe yourself. DANGER: High Voltage inside! Seek your

local dealer for assistant should you encounter problem with your strobe.

1 2 3 4 5 6 7

Résumé du contenu

Page 1 - Safety Instructions

IntroductionThank you for purchasing a RiMELITE product. The i-series battery built in strobe incorporates someof the advance features in its lightwei

Page 2

i.2 / i.4 User Manual1. Control Dial for Flash Power .2. Control Dial for LED Modeling Light.3. RPT - Stroboscopic (C Mode) Button.4. Short Flash

Page 3 - Initial Setup

Initial SetupThe i-series flash unit ships with a Hard Plastic Protective Cover, in place over the flashtube and PyrexGlass Dome to protect these ite

Page 4

“T” or High Flash Duration ModeŸ This is the mode designed for a shorter flash duration for high speed photography purpose (such aswater droplet)Ÿ To

Page 5

Please follow the steps below for engaging the “C” modeŸ Make sure the flash power output is either 1.0, 1.5, 2.0 or 2.5 in the normal mode or t1 and

Page 6 - Specification

SpecificationModelunit i2 i4Flash PowerJ(J/W) 200 400F-Stope,1m,ISO100,With hard type reflector: RST-164H22 32Power range(W)6~200 12~400Varia

Page 7

Recommended AccessoriesSwing II (Wireless Remote control and Flash Triggering System)The Swing II is the latest in the Swing System family. Its inheri

Commentaires sur ces manuels

Pas de commentaire

Rime-lite i flash Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Accessoires photo Rime-lite i flash. RiME LITE i flash User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Accessoires photo Rime-lite i flash